Altec 169Mhz Pill Dispenser

Carbon Monoxide Detectors should be wall mounted above door height in rooms that contain a fuel burning appliance. Do not fit in bathrooms, directly above cookers or in draughty areas. If a dangerous level of carbon monoxide is detected a local alarm will sound and an alarm call will be transmitted.

Features include

• Electrochemical Cell sensor
• 85 dB sounder, power, fault & alarm LED indicators
• Test/Hush button
• Monthly self test & fault warning feature
• 5 years detector life (inc battery)
• Daily battery self test & low battery reporting
• Dimensions: 145 x 80 x 50 mm (HxWxD)
• Complies with BS EN 50291: 2001
• Carbon Monoxide Detector Part No. ZXT422
• Compatible with SayPhone, Advent xt & Altec Response

The Epilepsy Monitor bed sensor pads should be positioned under the mattress to detect arm and leg movements. If a Tonic Clonic seizure is detected in the bed an alarm call is transmitted.

Features include

• 2 under mattress sensor pads
• Sophisticated digital processor
• 3 sensitivity settings
• LED indication of sensitivity setting
• Supplied with Mains Adapter
• 5 Years Transmitter battery life (typical)
• Daily battery self test & low battery reporting
• Dimensions: 125 x 69 x 24 mm (HxWxD)
• Epilepsy Monitor Part No. ZXT441
• Compatible with SayPhone, Advent xt & Altec Response

The Double Adapter can be used to connect 2 Bed Sensors (i.e. in a double bed) or 2 Pressure Mats/Door Contacts to a single Sensor Controller.

Features Include

• Fully connected RJ45 splitter
• Simple plug-in connection
• Double Adapter Part No. P10285
• Compatible with Tynetec Sensor Controller

The Sensor Controller can be used with a Bed Sensor, Chair Sensor, Pressure Mat or Door Contact. If a person gets into bed/sits in their chair, then gets up again and does not return within the preset time an alarm call will be transmitted. With the pressure mat/door contact an alarm will be transmitted 1 minute after the sensor is activated unless cancelled locally. Lamps etc. can be turned on/off automatically using a Remote Controlled Mains Switcher Kit.

Features include

• 7 day time clock with battery back-up
• Up to 6 monitoring periods per day
• 10, 20 or 50 minute time-out options
• Multifunction pushbutton and Status LED indicator
• Test Mode to simplify set-up
• Supplied with battery and 240V AC adaptor
• 6 months battery life (typical)
• Daily battery self test & low battery reporting
• Dimensions: 35 x 85 x 170 mm (HxWxD)
• Sensor Controller Part No. ZXT430
• Compatible with SayPhone, Advent xt & Altec Response

The Temperature Extreme Sensor should be wall mounted in the hallway or living room away from any draughts or heat sources. This will provide early warning of extreme low or high household temperatures which could result in the occupier suffering hypothermia or dehydration. In addition, the building will also be protected against burst pipes or potential fire hazards.

Features include

• Solid state temperature sensing element
• Lower alarm temperature: 5 degrees C for 30 minutes
• Upper alarm temperature: 30 degrees C for 5 minutes
• Rate of rise alarm temperature: 8 degrees C per minute
• 3 years battery life (typical) - user replaceable 3.6V Lithium
• Daily battery self test & low battery reporting
• Dimensions: 84 x 84 x 36 mm (HxWxD)
• Temperature Extreme Sensor Part No. ZXT426
• Compatible with SayPhone, Advent xt & Altec Response

Ceiling Pullcord switches can be fitted in bathrooms, alongside the bed or anywhere Personal Pendants are not usually worn. An alarm call is made by simply pulling the cord once. The cord is long enough to reach floor level. Pullcord switches are available as radio or hardwired.

Features include

• 2.7 metre orange nylon cord
• 2 triangular orange grips
• 5 years battery life (typical)
• Daily battery self test & low battery reporting
• Dimensions: 85mm diameter x 40 mm deep
• Radio Pullcord Part No. ZXT435
• Standard Hardwired Pullcord Part No. S00510
• Compatible with SayPhone, Advent xt & Altec Response

Not only can it automatically detect a fall but it can also be used to detect stumbles, trips or recovered falls. If a fall is detected the unit will enter a pre-alarm state indicated by fast beeps and a green flashing LED. If the unit is not returned to the vertical position during the pre-alarm period, an emergency alarm call will be made via an At Home Alarm Unit or Advent xt Grouped System. This results in a flashing red LED on the fall detector.

Where a stumble or a trip is detected, the unit logs this information to either a SayPhone 21 At Home Alarm unit or an Advent xt Grouped System. The data can then be accessed and analysed using Tynetec's Altera Care Software. This can then be used to look for early intervention opportunities that can ultimately lead to a reduction in emergency hospital admissions.

A normal alarm call can be made at any time by pressing the red button.

Features include

• Solid state dual axis accelerometer sensor
• 5 user selectable levels of sensitivity
• 3 event logs; impacts, pre-alarms & alarms
• 1 year battery life (typical) - user replaceable 3.6V Lithium
• Daily battery self test & low battery reporting
• Dimensions: 85 x 56 x 20 mm (H x W x D)
• Weight: 68 grams
• Range: 75 metres (typical)
• Fall Detector Part No. ZXT410
• Optional Elasticated Belt Part No. YW9946
• Compatible with SayPhone, Advent xt & Altec Response

The Door Contacts can be used to monitor any controlled door. If the door is opened an alarm call will be transmitted immediately.

Features include

• Surface mount single gang pattress
• N/O surface mount door contacts supplied
• 5 years battery life (typical)
• Daily battery self test & low battery reporting
• Dimensions: : 87 x 87 x 40 mm (HxWxD)
• Door Contacts Part No. ZXT434
• Compatible with SayPhone, Advent xt & Altec Response

The Keypad should be wall mounted within the dwelling with the contacts wired to the door and the mains adapter plugged into a 13A socket. Before the Carer leaves they enter a code to start the exit time period. When the exit time period expires the door is armed. When the door is opened the entry time period starts. If the code is not entered within the entry time an alarm call will be transmitted.

Features include

• Programmable 4 digit arm/disarm code
• Programmable entry & exit times
• Integral entry/exit sounder
• Instant alarm zone option
• Flip-cover & illuminated keypad
• Test facility
• Supplied with mains adapter & door contacts
• 5 years transmitter battery life (typical)
• Daily battery self test & low battery reporting
• Dimensions: 135 x 90 x 27 mm (HxWxD)
• Wandering Alarm Part No. ZXT433
• Compatible with SayPhone, Advent xt & Altec Response