CS1 Ceiling Pull Switch

CS1 Ceiling Pull Switch

Share
Our Price £10.50
Reward Points 52
Quantity

Description

Specifically developed to give alarms from bathrooms and toilets. The unit is ceiling mounted and features a floor length cord terminated with two easy to use G loops. It also incorporates twin integral reassurance indicators, which flash to confirm a call has been generated.

Related Products...

Fused Junction Board

The FJB2 provides four 'spur' outputs from the network spine with each output incorporating an over current/voltage and reverse polarity protection device. A front panel mounted red/green LED indicates the condition of the internal fuses and continuously monitors the network data signals. Individual fuse failure LEDs are mounted on the reverse of the unit and in the event of cable fault, on one of the outputs, the 'spur' will be isolated without disbaling the entire cable network.

£37.00

KS1 Isolating Keyswitch

Used to isolate monitoring devices such as PIR1 or door contact.

£22.00

L622M Standard Call Point with Magnetic Reset

The L622M is the magnetic reset version of the standard call point. It is non-audio and can generate up to 6 independent call levels indicated by the twin colour re-assurance LED. The 'call follower' sounder whih is activated when the call point is in 'staff present' mode, alerts staff to other calls on the system. The jack socket will accept any closing contact input from pear leads, pressure mats, radio triggers and a host of other trigger devices.

£65.00

SW1 Day/Night Volume Control Switch

Manual control switch to allow volumes to be quieter at night or when required.

£25.00

L733 Door Monitoring/Access Control Point

If you need to protect fire doors, entrance & exit doors or other sensitive areas, the L733 is the ideal solution. The unit is controlled with a key token, which performs all functions when brought near the token detection area on the front panel. The unit also features an integral 20-second exit timer with audible bleep and mode jumper to prevent sensitive or dangerous exit doors being permanently left open.

£58.00

L746S Addressable Overdoor Light with Sounder

These are normally positioned above doors in a corridor to indicate the status of the call point(s) within each room. The L746s can also be used to monitor several call points for end of corridor indication, or as a 'follow me' light. Each unit is fitted with twin ultra-bright LEDs which mimic the reassurance indicator on the call points. The sounder mimics the LCD display sounding patterns.

£43.00

PIR1 Passive Infra Red Bed Monitor

If you need to monitor a resident's bed and alert staff when he or she is on the move, the PIR1 bed monitor will detect movement and alert the staff. However, the bed itself is 'masked' out of the range of the detector so that it only monitors movement outside the bed area. Any movement within the receiver's range will activate a call, and trigger the call point.

£40.00

M1 Magnetic Door Contact

Installed in conjunction with door monitoring unit or call point and isolation switches. Activates paired call point when door is opened.

£12.00

SCP Slave Call Point

Designed for use in one room or ward where each individual bed doesn't need a separate identity on the call system. The unit features a call button, pear lead jack socket and re-assurance indicator.

Units must be connected to a standard call point to generate the call identity and to provide the reset. Slave call points can only generate a standard call from either the call button or pear lead socket.

£23.00

More...

Send to Friend

: *
: *
: *
Type the letters you see in the picture:
Captcha

*