The website uses cookies to allow us to better understand how the site is used. By continuing to use this site, you consent to this policy. Click to learn more. 
    
 

Chair Sensor

Chair Sensor

Share
Our Price £259.82
Reward Points 1299
Quantity

Manufacturer Tynetec

Description

The Chair Sensor should be positioned under the seat cushion, monitoring periods are set on the Sensor Controller. If a person sits down, then gets up again and does not return within the preset time an alarm call will be transmitted. A table lamp can be turned on/off automatically using a Remote Controlled Mains Switcher Kit. All "in-chair" and "out-of-chair" activity is transmitted and logged.

Features include

  • Chair sensor dimensions: 325 x 130 mm
  • 1.5 metre lead with locking plug-in connector
  • Double adapter available for 2 sensors per chair
  • 4 levels of sensitivity with auto-calibration
  • Up to 6 monitoring periods per day
  • 10, 20 or 50 minute out-of-chair timeout options
  • Chair Sensor Part No. ZCS859
  • Compatible with Tynetec Sensor Controller

Related Products...

Altec 169 Mhz Temp Extreme Sensor

The Temperature Extreme Sensor should be wall mounted in the hallway or living room away from any draughts or heat sources. This will provide early warning of extreme low or high household temperatures which could result in the occupier suffering hypothermia or dehydration. In addition, the building will also be protected against burst pipes or potential fire hazards.

Features include

  • Solid state temperature sensing element
  • Lower alarm temperature: 5 degrees C for 30 minutes
  • Upper alarm temperature: 30 degrees C for 5 minutes
  • Rate of rise alarm temperature: 8 degrees C per minute
  • 3 years battery life (typical) - user replaceable 3.6V Lithium
  • Daily battery self test & low battery reporting
  • Dimensions: 84 x 84 x 36 mm (HxWxD)
  • Temperature Extreme Sensor Part No. ZXT426
  • Compatible with SayPhone, Advent xt & Altec Response

£99.52

Altec 169Mhz Fall Detector

Not only can it automatically detect a fall but it can also be used to detect stumbles, trips or recovered falls. If a fall is detected the unit will enter a pre-alarm state indicated by fast beeps and a green flashing LED. If the unit is not returned to the vertical position during the pre-alarm period, an emergency alarm call will be made via an At Home Alarm Unit or Advent xt Grouped System. This results in a flashing red LED on the fall detector.

Where a stumble or a trip is detected, the unit logs this information to either a SayPhone 21 At Home Alarm unit or an Advent xt Grouped System. The data can then be accessed and analysed using Tynetec's Altera Care Software. This can then be used to look for early intervention opportunities that can ultimately lead to a reduction in emergency hospital admissions.

A normal alarm call can be made at any time by pressing the red button.

Features include

  • Solid state dual axis accelerometer sensor
  • 5 user selectable levels of sensitivity
  • 3 event logs; impacts, pre-alarms & alarms
  • 1 year battery life (typical) - user replaceable 3.6V Lithium
  • Daily battery self test & low battery reporting
  • Dimensions: 85 x 56 x 20 mm (H x W x D)
  • Weight: 68 grams
  • Range: 75 metres (typical)
  • Fall Detector Part No. ZXT410
  • Optional Elasticated Belt Part No. YW9946
  • Compatible with SayPhone, Advent xt & Altec Response

£120.38

Air Activated Switch

The Air Activated switch can be used in wet areas such as swimming pools or Jacuzzi's. The actuator pad is connected via PVC tubing to a wall mounted switch plate. An alarm call is made by simply squeezing the pad once.

£69.38

Altec 169Mhz Flood Detector

Flood Detectors should be located on the floor below the bath, wash basin or kitchen sink or anywhere a tap could be left running. Flood Detectors can be free standing or screw fixed to the skirting board with an optional mounting bracket. If a flood is detected an alarm call will be transmitted.

Features include

  • Moisture Bridge Sensor
  • Activated LED indicator
  • 5 years battery life (typical)
  • Daily battery self test & low battery reporting
  • Dimensions: 50 x 95 x 18 mm (HxWxD)
  • Flood Detector Part No. ZXT424
  • Optional Mounting Bracket Part No. V00770
  • Compatible with SayPhone, Advent xt & Altec Response

£58.37

Radio Door Contact

The Door Contacts can be used to monitor any controlled door. If the door is opened an alarm call will be transmitted immediately.

Features include

  • Surface mount single gang pattress
  • N/O surface mount door contacts supplied
  • 5 years battery life (typical)
  • Daily battery self test & low battery reporting
  • Dimensions: : 87 x 87 x 40 mm (HxWxD)
  • Door Contacts Part No. ZXT434
  • Compatible with SayPhone, Advent xt & Altec Response

Double Adaptor

The Double Adapter can be used to connect 2 Bed Sensors (i.e. in a double bed) or 2 Pressure Mats/Door Contacts to a single Sensor Controller.

Features Include

  • Fully connected RJ45 splitter
  • Simple plug-in connection
  • Double Adapter Part No. P10285
  • Compatible with Tynetec Sensor Controller

£14.48

Vibrating Pad

The Vibrating Pad can be used under a pillow or cushion to alert hard of hearing residents when the Local Manager or Control Centre is trying to contact them.

Features include

  • 100mm diameter vibrating pad
  • 1.5 metre lead with locking jack plug
  • Supplied with single gang wall plate & jack socket
  • Triggered automatically by a call to an Advent xt intercom
  • Connects to Strobe Light or separate interface board
  • Vibrating Pad Part No. W00360
  • Optional interface (if used without strobe) Part No. A00452
  • Compatible with Advent XT systems only

Door Contact

The Door Contacts can be used to monitor any controlled door. If the door is opened with the keyswitch in the "Normal" position an alarm call will be transmitted. If the door needs to be opened for a genuine reason the keyswitch can be turned to the "Override" position.

Features include

  • Surface mount single gang pattress
  • 2 position Keyswitch (2 keys supplied)
  • Key removable in both positions
  • N/O surface mount door contacts supplied
  • 5 years battery life (typical)
  • Daily battery self test & low battery reporting
  • Dimensions: 87 x 87 x 40 mm (HxWxD)
  • Door Alarm & Keyswitch Part No. ZXT438
  • Compatible with SayPhone, Advent xt & Altec Response

£59.32

Altec 169 Mhz Combined Gas & Carbon Monoxide Detector

Combined Gas & Carbon Monoxide Detectors should be wall mounted above door height in all rooms that contain a fuel burning appliance. Do not fit in bathrooms, directly above cookers or in draughty areas. If a dangerous level of gas or carbon monoxide is detected a local alarm will sound and an alarm call will be transmitted.

Features include

  • Gas - Nemoto Catalytic sensor
  • CO - Electrochemical Cell sensor
  • 85 dB sounder, power, fault, gas & CO alarm LED indicators
  • Requires 240V AC mains supply via a fused spur
  • 1 Watt power consumption
  • 5 years detector life (inc transmitter battery)
  • Daily battery self test & low battery reporting
  • Dimensions: 150 x 115 x 53 mm (HxWxD)
  • Combined Gas & CO Detector Part No. ZXT427

£264.65

More...

Send to Friend

: *
: *
: *
Type the letters you see in the picture:
Captcha

*