L752 Audio Call Point

Manual control switch to allow volumes to be quieter at night or when required.

The RB1 relay board converts the O/C output from the LCD displays and L746 Overdoor light into 'Normally open' and 'Normally closed' contact sets. The unit may also be configured by the fatory to provide time delays for some door applications. It may aksi be used to trigger a call point from an external voltage (e.g. door bell etc.). The unit is fitter with a 'T' 12v output which may be usedto drive low current devices from the newtork.

Designed to be worn by residents or staff and enables calls to be generated remotely from the call point. This is ideal outside or in lounges or common rooms where each resident can be given a trigger to allow access to the call system. The TRf4 requires an infra red or radio enabled call point to operate. When using the TRF4 with an integral 700 system, it is possible to identify the call location and the individual caller.

A call point is needed for every individual call location on the system. Every L622 unit features five levels of call, multi-colour re-assurance LED alerts and a 'call follower' sounder. The jack socket accepts inputs from a wide range of triggering devices such as pear leads, pressure mats and portable radio triggers. A magnetic reset option is also available (order code L622M) which only allows the reset function to be activated by the use of a magnetic key.

Even the most severely handicapped people can have access to your call system with the BC1 Breath Switch. It operates in a similar way to the pear leads and the air switch above, by generating a standard call, and plugs into the jack on all Intercall call points. It is supplied with detachable mouth-pieces which can be sterilized.

Used to isolate monitoring devices such as PIR1 or door contact.

The Touch Display Plus has all the functionality of our Touch Display, with the addition of a full duplex VoIP speech device. The Touch Display Plus is the heart of the Intercall Touch Series. Perfect for larger hospitals or smaller care residences, the Touch Display Plus is the central hub of the Touch Series nurse call system. Ideally installed on a desk, the Touch Display Plus is the primary nurse call system staff interaction point. It helps nursing staff with monitoring while notifying them of calls and alerts on the system. The Touch Display Plus allows staff to speak to patients and residents through its VoIP intercom system, allowing them to decide the most appropriate response.

Transmission Control Protocol / Internet Protocol is the basic communication language or protocol of the internet. Information is broken down into small packets of all shapes and sizes and transmitted around the network or internet, which allows for data to be transferred quickly and efficiently between a variety of networks.

Via TCP/IP connection, Intercall's L7700 Power supply has the ability to link with many third party devices, such as IP DECT Phones, IP Message Pagers, PDA's, and front end GUI software.

The IP power supply comes complete with integral call logging.

The FJB2 provides four 'spur' outputs from the network spine with each output incorporating an over current/voltage and reverse polarity protection device. A front panel mounted red/green LED indicates the condition of the internal fuses and continuously monitors the network data signals. Individual fuse failure LEDs are mounted on the reverse of the unit and in the event of cable fault, on one of the outputs, the 'spur' will be isolated without disbaling the entire cable network.