The website uses cookies to allow us to better understand how the site is used. By continuing to use this site, you consent to this policy. Click to learn more. 
    
 

Sensor Controller

Sensor Controller

Share
Our Price £174.78
Reward Points 873
Quantity

Description

The Sensor Controller can be used with a Bed Sensor, Chair Sensor, Pressure Mat or Door Contact. If a person gets into bed/sits in their chair, then gets up again and does not return within the preset time an alarm call will be transmitted. With the pressure mat/door contact an alarm will be transmitted 1 minute after the sensor is activated unless cancelled locally. Lamps etc. can be turned on/off automatically using a Remote Controlled Mains Switcher Kit.

Features include

  • 7 day time clock with battery back-up
  • Up to 6 monitoring periods per day
  • 10, 20 or 50 minute time-out options
  • Multifunction pushbutton and Status LED indicator
  • Test Mode to simplify set-up
  • Supplied with battery and 240V AC adaptor
  • 6 months battery life (typical)
  • Daily battery self test & low battery reporting
  • Dimensions: 35 x 85 x 170 mm (HxWxD)
  • Sensor Controller Part No. ZXT430
  • Compatible with SayPhone, Advent xt & Altec Response

Related Products...

Chair Sensor

The Chair Sensor should be positioned under the seat cushion, monitoring periods are set on the Sensor Controller. If a person sits down, then gets up again and does not return within the preset time an alarm call will be transmitted. A table lamp can be turned on/off automatically using a Remote Controlled Mains Switcher Kit. All "in-chair" and "out-of-chair" activity is transmitted and logged.

Features include

  • Chair sensor dimensions: 325 x 130 mm
  • 1.5 metre lead with locking plug-in connector
  • Double adapter available for 2 sensors per chair
  • 4 levels of sensitivity with auto-calibration
  • Up to 6 monitoring periods per day
  • 10, 20 or 50 minute out-of-chair timeout options
  • Chair Sensor Part No. ZCS859
  • Compatible with Tynetec Sensor Controller

£259.82

Altec 169 Mhz Temp Extreme Sensor

The Temperature Extreme Sensor should be wall mounted in the hallway or living room away from any draughts or heat sources. This will provide early warning of extreme low or high household temperatures which could result in the occupier suffering hypothermia or dehydration. In addition, the building will also be protected against burst pipes or potential fire hazards.

Features include

  • Solid state temperature sensing element
  • Lower alarm temperature: 5 degrees C for 30 minutes
  • Upper alarm temperature: 30 degrees C for 5 minutes
  • Rate of rise alarm temperature: 8 degrees C per minute
  • 3 years battery life (typical) - user replaceable 3.6V Lithium
  • Daily battery self test & low battery reporting
  • Dimensions: 84 x 84 x 36 mm (HxWxD)
  • Temperature Extreme Sensor Part No. ZXT426
  • Compatible with SayPhone, Advent xt & Altec Response

£99.52

Altec 169Mhz Carbon Monoxide Detector

Carbon Monoxide Detectors should be wall mounted above door height in rooms that contain a fuel burning appliance. Do not fit in bathrooms, directly above cookers or in draughty areas. If a dangerous level of carbon monoxide is detected a local alarm will sound and an alarm call will be transmitted.

Features include

  • Electrochemical Cell sensor
  • 85 dB sounder, power, fault & alarm LED indicators
  • Test/Hush button
  • Monthly self test & fault warning feature
  • 5 years detector life (inc battery)
  • Daily battery self test & low battery reporting
  • Dimensions: 145 x 80 x 50 mm (HxWxD)
  • Complies with BS EN 50291: 2001
  • Carbon Monoxide Detector Part No. ZXT422
  • Compatible with SayPhone, Advent xt & Altec Response

£140.91

Ambient Temperature Monitor

The Ambient Temperature Monitor should be wall mounted in the hallway or living room away from any draughts or heat sources. When used in conjunction with a PIR, this device can be used to assess whether a client is potentially at risk from hypothermia e.g. if they are not using their central heating system at night or during winter months. The unit will generate a warning signal should the temperature drop below 16 degrees C and will activate an alarm condition should the temperature fall below 10 degrees C for 30 minutes.

Features include

  • Solid state temperature sensing element
  • Lower alarm temperature: 10 degrees C for 30 minutes
  • Upper temperature threshold: 16 degrees C
  • 3 years battery life (typical) - user replaceable 3.6V Lithium
  • Daily battery self test & low battery reporting
  • Dimensions: 84 x 84 x 36 mm (HxWxD)
  • Ambient Temperature Monitor No. ZXT442
  • Compatible with SayPhone, Advent xt & Altec Response

£99.52

Altec 169Mhz Flood Detector

Flood Detectors should be located on the floor below the bath, wash basin or kitchen sink or anywhere a tap could be left running. Flood Detectors can be free standing or screw fixed to the skirting board with an optional mounting bracket. If a flood is detected an alarm call will be transmitted.

Features include

  • Moisture Bridge Sensor
  • Activated LED indicator
  • 5 years battery life (typical)
  • Daily battery self test & low battery reporting
  • Dimensions: 50 x 95 x 18 mm (HxWxD)
  • Flood Detector Part No. ZXT424
  • Optional Mounting Bracket Part No. V00770
  • Compatible with SayPhone, Advent xt & Altec Response

£58.37

Altec 169Mhz Fall Detector

Not only can it automatically detect a fall but it can also be used to detect stumbles, trips or recovered falls. If a fall is detected the unit will enter a pre-alarm state indicated by fast beeps and a green flashing LED. If the unit is not returned to the vertical position during the pre-alarm period, an emergency alarm call will be made via an At Home Alarm Unit or Advent xt Grouped System. This results in a flashing red LED on the fall detector.

Where a stumble or a trip is detected, the unit logs this information to either a SayPhone 21 At Home Alarm unit or an Advent xt Grouped System. The data can then be accessed and analysed using Tynetec's Altera Care Software. This can then be used to look for early intervention opportunities that can ultimately lead to a reduction in emergency hospital admissions.

A normal alarm call can be made at any time by pressing the red button.

Features include

  • Solid state dual axis accelerometer sensor
  • 5 user selectable levels of sensitivity
  • 3 event logs; impacts, pre-alarms & alarms
  • 1 year battery life (typical) - user replaceable 3.6V Lithium
  • Daily battery self test & low battery reporting
  • Dimensions: 85 x 56 x 20 mm (H x W x D)
  • Weight: 68 grams
  • Range: 75 metres (typical)
  • Fall Detector Part No. ZXT410
  • Optional Elasticated Belt Part No. YW9946
  • Compatible with SayPhone, Advent xt & Altec Response

£120.38

Strobe Light

A flashing Strobe Light is used to alert hard of hearing residents when the Local Manager or Control Centre is trying to contact them.

Features include

  • Wall mounted enclosure: 110mm diameter x 70mm deep
  • 50mm diameter blue strobe light
  • Triggered automatically by a call to an Advent xt intercom
  • Flash duration: 20 seconds
  • Advent xt Strobe Light Part No. ZSL045
  • Compatible with Advent xt systems only

£63.06

Air Activated Switch

The Air Activated switch can be used in wet areas such as swimming pools or Jacuzzi's. The actuator pad is connected via PVC tubing to a wall mounted switch plate. An alarm call is made by simply squeezing the pad once.

£69.38

PIR Movement Detector

PIR Movement Detectors should be wall mounted at high level in the hallway or living room to monitor movement within the dwelling. PIR's can be used for activity monitoring or intruder detection;

Activity Mode; if no movement is detected within a preset period an "inactivity" alarm call will be transmitted.

Intruder Mode; if movement is detected an "intruder" alarm call will be transmitted.

Features include

  • Passive Infra Red sensor
  • Walk Test LED indicator
  • 2 minute signal time mask to prolong battery life
  • Pet Alley option to prevent false calls from pets
  • 1 year battery life (typical with 9V Lithium battery)
  • Daily battery self test & low battery reporting
  • Dimensions: 114 x 70 x 76 mm (HxWxD)
  • PIR Movement Detector Part No. ZXT425
  • Compatible with SayPhone and Advent xt systems

£73.08

More...

Send to Friend

: *
: *
: *
Type the letters you see in the picture:
Captcha

*